Workable with Autel IM608, CGDI and VVDI MB, Key Tool Plus
Xhorse VVDI BE Key Pro Improved Version Get 1 Free Token for VVDI MB Tool
Xhorse VVDI BE Key Pro Improved Version
The Xhorse VVDI BE Key Pro offers the following features:
Digital signature for added security
VVDI BE key Pro improvements:
Resolved the issue where W164 / W639 EIS data does not synchronize with the key.
Fixed the problem of the BE key ceasing to function after repeatedly turning the ignition on and off without removing the key from the EIS / EZS. For instance, this may occur during diagnostic work or when resetting faults.
Corrected the trunk remote open bug, primarily affecting vehicles with power lifts on the trunk door.
Improved the BE key's RF signal transmission. Previously, it only sent an RF signal once, but after the update, the RF signal can be sent twice upon pressing and releasing the key.
Adjusted the rolling algorithm to address errors associated with the BE key.
Added a pre-roll algorithm that allows the HASH value to roll ahead.
Utilized car-grade quartz crystal to enhance infrared communication stability.
Amplified the infrared signal when the key button is pressed.
Introduced support for resetting the key frequency between 315MHZ and 433.92MHZ using either the VVDI MB tool or the PCB SMD resistor.
Note: When it comes to resetting the key frequency, the VVDI MB tool takes priority over the SMD resistor. This means that if you initially reset the frequency with the VVDI MB tool, the SMD resistor will not work. To use the SMD resistor, you will need to erase the frequency using the VVDI MB tool first.
VVDI BE Key Package includes:
1pc x VVDI BE key Pro improved version
Here's a step-by-step guide on how to assemble the VVDI BE Key Pro improved version with the Smart Key Shell 3 Button for Mercedes Benz:
Insert the VVDI BE Key Pro improved version PCB into the case.
Securely cover the bottom case.
Insert the battery and close the case.
Ensure the metal strips on both sides are correctly positioned by pushing them into place.
Note: If the rear metal component is assembled first, the metal strips on both sides will not align properly.
Attach the rear metal button.
Place the small key and start button in their respective slots.
If you need to disassemble the case, please follow the steps in reverse order, starting from the last step and working your way back to the first step.
Note: If the rear metal component is firstly assembled, then the metal strips on both sides won&spos; t be able to put into the right position. We are here for you: